Filter
Top Products
3. Place the escutcheon plate over
the cable hole and use it as a guide
to mark the two escutcheon plate
mounting holes. Remove the plate,
drill two 9/64" (3.5 mm) holes, then
fill both holes with marine-grade
silicone sealant. Place the
escutcheon plate over the cable
hole and attach with two #8 x 5/8"
(16 mm) wood screws.
4. Route and secure the cable by
attaching the cable clamp to the
transom; drill one 9/64" dia. (3.5
mm) x 5/8" deep (16 mm) hole,
then fill hole with marine-grade
silicone sealant, then attach the
cable clamp using a #8 x 5/8" (16
mm) screw.
5. Plug the other end of the
transducer cable back into the
control head connection holder.
To perform a final test of the
transom transducer installation:
After transom transducer installation, please perform the final testing and then
finalize the installation (see Test and Finish the Transducer Installation).
Trolling Motor Transducer Installation
If you want to install the transducer on a trolling motor, use this procedure.
Several styles of the transducer are compatible with trolling motor mounting.
If you have a trolling motor bracket, refer to the separate installation
instructions that are included with the bracket.
NOTE: After trolling motor transducer installation, please perform the final
testing and then finalize the installation (see Test and Finish the Transducer
Installation).
Trolling Motor Transducer Options
If you don’t have a trolling motor transducer,
there are several options:
• You may purchase a Trolling Motor Adapter kit
that will allow you to mount the transducer on the
trolling motor.
• You may also exchange your NEW and UNASSEMBLED transducer
(with mounting hardware included) for a trolling motor transducer.
There are also several transducer switches available that support the
following configurations:
• Two control heads with one transducer
• Two transducers with one control head.
NOTE: Call the Humminbird® Customer Resource Center (1-800-633-1468) for
details and pricing, or visit www.humminbird.com for more information.
5/8” Hole
Escutcheon
Plate
Cable Clamp
Routing the Cable
19