Filter
Top Products
4 - 1
4-1 PREPARATION
Some adjustments must be performed on the “ADJUSTMENT MODE”. CS-FR3000 CLONING SOFTWARE, OPC-478 CLONING
CABLE and OPC-592 ADAPTOR CABLE are required when entering the adjustment mode. Refer to the next page in detail.
■ REQUIRED TEST EQUIPMENT
SECTION 4 ADJUSTMENT PROCEDURES
EQUIPMENT
DC power supply
RF power meter
(terminated type)
Frequency counter
FM deviation meter
GRADE AND RANGE
Output voltage : 13.6 V DC [FR3000]
13.2 V DC [FR3100]
Current capacity : 25 A or more
Measuring range : 1–100 W
Frequency range : 100–300 MHz
Impedance : 50 Ω
SWR : Less than 1.2 : 1
Frequency range : 0.1–600 MHz
Frequency accuracy : ±1 ppm or better
Sensitivity : 100 mV or better
Frequency range : DC–600 MHz
Measuring range : 0 to ±5 kHz
EQUIPMENT
Audio generator
Attenuator
Standard signal
generator (SSG)
AC millivoltmeter
Oscilloscope
Digital multimeter
GRADE AND RANGE
Frequency range : 300–3000 Hz
Output level : 1–500 mV
Power attenuation : 40 or 50 dB
Capacity : 100 W or more
Frequency range : 120–600 MHz
Output level : 0.1 µV–32 mV
(–127 to –17 dBm)
Measuring range : 10 mV–10 V
Frequency range : DC–20 MHz
Measuring range : 0.01–20 V
Input impedance : 10 MΩ/V DC or better
RF power meter
1–100 W / 50 Ω
Attenuator
40 dB or 50dB
FM deviation meter
(DC measurable)
Oscilloscope
DC power supply
13.6 V/25 A [FR3000]
13.2 V/25 A [FR3100]
Standard signal
generator
–127 to –17 dBm
Frequency
counter
JIG CABLE
[TX]
[RX]
[BATTERY]
[MIC]
OPC-478 + OPC-592
RS-232C
connector
Audio
generator
Microphone connector
MIC GND
MIC INPUT
–
+
PTT
18
GND
AC
millivoltmeter
Personal
computer
• CONNECTION