Filter
Top Products
9
3 FREQUENCY AND CHANNEL SETTING
New2001
■ Setting a frequency
qPush [V/M•S.MW•~] to select VFO mode, if necessary.
wSelect the desired frequency band with [BAND• ].
• Or, while pushing and holding [BAND• ], rotate the [DIAL] to
select the desired frequency band.
eRotate [DIAL] to select the desired frequency band.
• The frequency changes according to the preset tuning steps.
See the right section for setting the tuning step.
• While pushing and holding [FUNC], rotate [DIAL] to change the
frequency in 1 MHz steps (default).
The 1 MHz tuning step (dial select step) can be set to
100 kHz, 1 MHz or 10 MHz tuning steps in set mode. See
p. 15 for details.
■ Setting a tuning step
The tuning step can be selected for each frequency band,
however, the tuning steps, 8.33 kHz and 9 kHz, are appeared
when setting the tuning step for the VHF air band and AM
broadcast band, respectively. The following tuning steps are
available for the IC-R5.
• 5.0 kHz • 6.25 kHz • 8.33 kHz • 9.0 kHz
• 10.0 kHz • 12.5 kHz • 15.0 kHz • 20.0 kHz
• 25.0 kHz • 30.0 kHz • 50.0 kHz • 100.0 kHz
DD
Tuning step selection
qPush [V/M•S.MW•~] to select VFO mode, if necessary.
wPush [BAND• ] to select the desired frequency band.
• Or, while pushing and holding [BAND• ], rotate the [DIAL] to
select the desired frequency band.
ePush [TS•SET] to enter tuning step selecting condition.
rRotate [DIAL] to select the desired tuning step.
tPush [TS•SET] to return to VFO mode.
[DIAL]
[TS•SET]
5 kHz tuning step
FM
75
50
25
FM
75
50
25
[BAND• ]
[DIAL]
[FUNC]
[DIAL] changes the frequency
according to the selected tuning
step.
While pushing [FUNC], [DIAL]
changes the frequency in 1 MHz
steps (default).
IC-R5_1.qxd 02.10.23 11:28 Page 9 (1,1)