Filter
Top Products
50
10
OTHER FUNCTIONS
New2001
10
DD
Weather alert function
NOAA broadcast stations transmit weather alert tones before
important weather announcements. When the weather alert
function is turned ON, the selected weather channel is moni-
tored each 5 sec. for the announcement. When the alert sig-
nal is detected, the “AL.T” and the WX channel are displayed
alternately and sounds a beep tone until the receiver is oper-
ated. The previously selected (used) weather channel is
checked periodically during standby or while scanning.
qSelect the desired weather channel.
wTurn the weather alert function ON in set mode.
➥ Push [TS•SET] to enter set mode.
➥ Rotate [DIAL] to select the weather alert item, then ro-
tate [DIAL] while pushing and holding [FUNC] to set
ON.
➥ Push [TS•SET] to exit set mode.
eSet the desired stand-by condition.
• Select VFO or memory channel.
• Scan or priority watch operation can also be selected.
rWhen the alert is detected, a beep sounds and the follow-
ing indication will be displayed.
t Turn the weather alert function OFF in set mode.
NOTE: While receiving a signal (on a frequency other than
the weather alert ON frequency), the receiving signal or
audio will be interrupted momentarily every 5 sec.
(approx.)
in case the alert function is turned ON. This symptom is
caused by the WX alert function. To cancel these symp-
toms, set the weather alert item OFF in set mode.
FM FM
Show above indications alternately.
IC-R5_1.qxd 02.10.23 11:29 Page 50 (1,1)