Filter
Top Products
New2001
q
w
e
r
■ Memory channel programming
Set the desired frequency and
other functions in VFO mode.
Push [V/M•S.MW•~] for 1 sec.
to enter select memory write
condition.
• 1 short and 1 long beeps sound.
Rotate [DIAL] to select the
desired memory channel number.
Push [V/M•S.MW•~] for 1 sec.
again to program the contents
into the selected channel.
• 3 beeps sound.
q
w
e
■ Scan skip setting
Push [V/M•S.MW•~] to select
memory mode.
Rotate [DIAL] to select the
desired memory channel.
While pushing [FUNC], push
[V/M•S.MW•~] to set the skip
setting (skip channel or skip
frequency) ON and OFF.
q
w
■ VFO scans
Push [V/M•S.MW•~] to select
VFO mode.
Push [MODE•SCAN] for 1 sec.
• One of scan type “ALL,” “BAND” or
“PROG xx” (xx= 0–24) appear.
e
r
Rotate [DIAL] to select the
desired scan type.
Push [MODE•SCAN] momen-
tarily to start scan.
• Rotate [DIAL] to change the scanning
direction.
• During scan, push [V/M•S.MW•~]
to start auto memory write scan.
Push [MODE•SCAN] momen-
tarily again to stop scan.
q
w
■ Memory scans
Push [V/M•S.MW•~] to select
memory mode.
• Push [BAND• ] to select a bank,
if desired.
Push [MODE•SCAN] for 1 sec.
• One of scan type “ALL” or “BANK”
appear, for bank scan. Rotate [DIAL]
to select the desired scan type, in this
case.
• When memory mode is selected at
step q, memory scan starts.
e
r
Push [MODE•SCAN] momen-
tarily to start bank scan.
• Rotate [DIAL] to change the scanning
direction.
Push [MODE•SCAN] momen-
tarily again to stop scan.
IC-R5_1.qxd 02.10.23 11:29 Page 67 (1,1)