Filter
Top Products
12
INSTALLATION
2
(5) For wiring of the inverter which has one front cover, remove a hook of the front cover and use a space
become available.
For wiring of the inverter which has front covers 1 and 2, use the space on the left side of the control
circuit terminal block.
REMARKS
When the hook of the inverter front cover is cut off for wiring, the protective structure (JEM1030) changes to open type
(IP00).
Do not use empty terminals as junction terminals because they are used in the option unit. If
they are used as the junction terminals, the option unit may be damaged.
When performing wiring using the space between the inverter front cover and control circuit
terminal block, take care not to subject the cable to stress.
After wiring, wire offcuts must not be left in the inverter. They may cause a fault, failure or
malfunction.
Cut off a hook on the inverter
front cover side surface.
(Cut off so that no portion is left.)
Cut off
with a
nipper,
etc.
Control circuit
terminal block
Front cover
Front cover 2
Front cover 1
Inverter which has one front cover Inverter which has front covers 1 and 2
C
AUTI
O
N