Filter
Top Products
930-110-01 PowerLogic
TM
E4800 Series
02/2009 Installation
© 2009 Schneider Electric All Rights Reserved
15
Figure 9: PowerLogic E4880 80mA current transformer
Installing CTs on the PowerLogic E4833 and PowerLogic E4880
Do not apply power until you have made these connections and followed all
of the instructions below:
• connect all CTs to the appropriate circuits
• connect the CTs to the cables
• connect the cables to the PowerLogic E4800 meter
To install the mA current transformers on the PowerLogic E4880 or the
0.333V current transformers on the PowerLogic E4833, follow these steps:
1. Connect the 50-conductor cable to the meter CT input connector
located at the bottom side of the unit, and secure it in place with the
retaining clips.
2
3
1
Legend:
1 Source
2 Energy flow
3 Load
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH
• Turn off all power supplying this equipment before working on or
inside the equipment.
• Always use a properly rated voltage sensing device to confirm the
power is off.
• Do not crimp the insulation when making the wire connections.
Failure to follow these instructions will result in death or
serious injury.