Filter
Top Products
C AA010012 2 Kw Radar processor box. No cables supplied. Connects to GB40
system via Ethernet.
The Radar box requires heading @10hz. For Vessels using NMEA 0183
order cable NS004801 to connect to a suitable heading sensor.
2kW System is 12 V DC ONLY 25 W max Power connects to the two
screw terminals
D AA010151 AT10HE SimNet to NMEA0183 converter Converts SimNet heading to
0183 @10hz To allow for accurate MARPA and overlay.
Has two simnet ports to sit on simNet Bus and a 2 m (6ft) cable
terminating with 12 Pin Female connector. This plugs into socket
labeled NMEA COMS on the radar processor box
D1
NS004801 Utility Cable 2 m (6ft) This cable has 12 Pin Female connector on one
end and 12 bare wires on the other. This plugs into socket labeled
Utility on the 8000i or GB40 Master Navcomputer this cable is shipped
with each NavComputer
D2 NS004801 Same cable as D1 but needs to be ordered separately. Connects to the
radar processor labeled NMEA /COMS
E
Ethernet Cables: All ethernet cables need to be ordered. They are not
supplied with any product. They are available in four lengths as well as
self terminating bulk rolls
NS004810 Ethernet cable 0.5 m (1.6 ft) male / male connectors
NS004811 Ethernet cable 2 m (6.5 ft) male / male connectors
NS004812 Ethernet cable 5 m (16.5 ft) male / male connectors
NS004813 Ethernet cable 0.5 m (1.6 ft) male / male connectors
NS004814 Ethernet cable joiner 0.5 m (1.6ft) female / female
NS004817 Ethernet cable bulk roll 100m (328 ft) un-terminated
NS004818 Ethernet cable bulk roll 300m (985 ft) un-terminated
NS004816 Ethernet Connector. Field terminating ethernet connector for bull
ethernet cable
F NS004815 Ethernet cross-over joiner cable 0.5m (1.6 ft) Female / Female.
This can be used to connect no more than 2 network devices together
e.g a radar processor and a GB40 NavComputer.
The cable has Female connectors at each end. Two standard ethernet
cables are required to link to network devices.
Connector ends are red in colour
Tip:
When deciding which standard ethernet cables to order locate the
crossover joiner where logically a network linker could be placed in the
future if the system was upgraded
If more than 2 ethernet devices are going to be used please use the
Navico 8 Port Linker (see G)
G AA010009 Navico 8 Port Ethernet Linker: Used to connect more then two ethernet
devices together. Ships with power cable only. Order ethernet cables
additionaly. 12 / 24 V DC
H 2209195 RC42 Heading sensor (or use SimNet heading output from and
autopilot)
H 1 2209195 RC37 Race Compass or heading sensor with 10 Hz output.
Note: Make sure the heading sensor shares the same ground as the
NavComputer
I
Simrad GB40 NavComputer
I*
Simrad GB40 NavComputer second station