Filter
Top Products
TECHNICAL GUIDELINES
ENGINE WILL NOT START
1. DESS key remo ved.
– In stall DESS key over post.
2. ECM does not recognize the DESS key.
– Refer to an autho rized Sea -Do o dea ler.
3. Burnt fuse: main, electric start er or ECM.
– Check wiring then replace fuse(s).
4. Discharged battery.
– Refer to an autho rized Sea -Do o dea ler.
WARNING
Do not charge or bo ost the battery while installed on the watercraft. Elec-
trolyte is pois onous and dangerou s. Avoid contact with eyes, ski n and
clothing.
5. Battery connections, corroded or loose. Bad ground.
– Refer to an autho rized Sea -Do o dea ler.
6. Water-flooded engine.
– Refer to WATER-FLOODED ENGINE in SPECIAL PROCEDURES.
7. Faulty sensor or ECM.
– Refer to an autho rized Sea -Do o dea ler.
8. Seized jet pump.
– Try to clean. Otherwise, refer to an authorized Sea-Doo dealer.
ENGINE TURNS SL OWLY
1. Loose battery cable connections.
– Check/clean/tighten.
2. Discharged or weak battery.
– Refer to an autho rized Sea -Do o dea ler.
3. Worn starter.
– Refer to an autho rized Sea -Do o dea ler.
ENGINE TURNS NORMALLY BUT WILL NOT START
1. Fuel tank empty or water-co ntaminated.
– Refill. Siphon and fill with fr esh fuel.
2. Fou led/defective spark p lugs.
– Replace.
3. Blown fuse.
– Check wiring then replace fuse(s).
4. Water-flooded engine.
– Refer to WATER-FLOODED ENGINE in SPECIAL PROCEDURES.
114
______________