Filter
Top Products
CONTROLS/INSTRUMENTS/EQUIPMENTS
6. A djust trim to the desired position
using VTS buttons.
7. Push both VTS buttons a ga in s imul-
taneously to record trim position.
Trim pre-set positions are recorded and
readytobeused.
To record new settings, repeat proce-
dure.
Using Pre-Set Trim Positions
To set trim to the highest trim position
recorded, double-clic k on V TS upper
button (bow up).
To set trim to the lowest trim position
recorded, double-click on VTS low er
button (bow down).
If trim s etting is unique (one position),
double-click either o n the lower or up-
per VTS button.
smo2008-001-010_c
DOUBLE-CLICK TO USE PRE-SET
POSITIONS
Shift Lever
A push-p ull lever:
– Forw a rd
– Neutral
– Rev ers e.
WARNING
Shift lever should only
be used
when the engine is idling and wa-
tercraft is completely stopped. Do
not use as a grab handl
e.
WARNING
Only use reverse at slow s peed
and for the sh ortest time possib le.
Always ensure the path behind
is clear of objects and persons in-
cluding children playing in shallow
water.
NO TICE
Neverrevtheengineat
high RPM in reverse.
From the forward pos ition, pull the
lever to reverse. Push back to go to
forward. Always set in forward when
finished. To find the neutral, set in re-
verse then push back until the wa ter-
craft stops moving backwards.
Refer to
PRINCIPLE OF OPERATION
in
OPERATING INSTRUCTION S
section
for the description of the propulsion
system.
smo2008-001-012_a
TYP ICAL
1. Shift l eve r
2. Forward position
3. N eutral position
4. Reverse position
Inform ation C enter Gauge
Multifunction gauge that supplies s ev -
eral rea l time useful information to the
driver either in En glish, French or Span-
ish. See an authorized Sea-Doo dealer
for unit settings.
At start-up, all LCD segments and indi-
cator lights will tu rn on for 3 sec onds
each time the in fo rm ation center is
46
______________