Filter
Top Products
Installing the HI400
22
In an RV or vehicle installation, this will usually be the
vehicle chassis or a dedicated DC ground bus.
Connecting the AC input cord
To connect the AC input cord:
➢ Plug the AC input cord (located at the back of the
inverter) into a properly grounded 120 Vac, 15 A
receptacle connected to an external shorepower source
such as a utility grid or a generator.
When the shorepower AC source is supplied, the HI400 will
transfer the loads to the shorepower source and turn off the
inverter.
When the shorepower AC source is disconnected or fails, the
HI400 will automatically turn on the inverter and transfer the
loads to inverter power.
WARNING: Shock hazard
Connect the AC input cord only to a properly grounded
standard 120 Vac, 15 A receptacle. If the correct type of
receptacle is not available, have an electrician install
one.
Note: Connecting the AC input cord to the AC output
receptacle on the HI400 GFCI version will not power loads and
will cause the unit to malfunction. There should not be any
damage.