5: Commands and Levels
Sets a specific port for use as the local port.
<number> = the number of the port to use.
Discontinues sending email alerts upon establishing a
connect mode tunnel.
Discontinues sending email alerts upon closing a connect
mode tunnel.
Promotes the identified host, exchanging it place with the
host above it,
to adjust the order of the defined hosts.
reconnect time <milliseconds>
Sets the reconnect time value for tunneling connections
established by the
device in milliseconds.
<milliseconds> = timeout in milliseconds.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Displays tunnel connect status.
start character <control>
Sets the connect mode start character.
The character may be input as text, control, decimal, or
hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
Stores the current configuration in permanent memory.
cp (email-cp:4) level commands
Exits to the next higher level.
Specify a CP group that shall trigger an email.
<text> = configurable pin group.
Disables the trigger to send an email.
Clears the value that shall trigger an email.
Shows the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Specify a value of the CP group that shall trigger an email.
<number> = numeric value to watch for from the CP
group. Can be specified as
hex if prepended with “0x”.
Stores the current configuration in permanent memory.
cp (email-cp:3) level commands
Exits to the next higher level.
Specify a CP group that shall trigger an email.
<text> = configurable pin group.
Disables the trigger to send an email.
Clears the value that shall trigger an email.
Shows the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Specify a value of the CP group that shall trigger an email.
XPort® Pro Lx6 Embedded Device Server Command Reference 44
