5: Commands and Levels
Sets the password required on the network side of the
tunnel to begin
Inhibits any prompting for password on the network side
of the tunnel.
Sets up so a user on the network side of the tunnel will be
prompted for
Shows the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
Run iperf with command line parameters passed in quot-
ed string.
Ping destination continuously with 5 second timeout
Ping destination n times with 5 second timeout
ping <host> <count> <timeout>
Ping destination n times with x timeout (in seconds)
Ping IPv6 destination continuously with 5 second timeout
Ping IPv6 destination n times with 5 second timeout
ping6 <host> <count> <timeout>
Ping IPv6 destination n times with x timeout (in seconds)
Displays the last 20 commands entered during the current
CLI session.
Trace route to destination
trace route <host> <protocol>
Trace route to destination using TCP, ICMP, or UDP
serial (tunnel-serial:1) level commands
Restores default DTR control, asserted while connected.
dtr asserted while connected
Asserts DTR whenever a connect or accept mode tunnel
connection is active.
dtr continuously asserted
Asserts DTR regardless of any connections.
Asserts DTR to match remote DSR when connected via
Telnet.
Returns to the tunnel level.
Displays the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
smtp (config-smtp) level commands
Restores the SMTP relay port to its default.
XPort® Pro Lx6 Embedded Device Server Command Reference 82
