5: Commands and Levels
Displays the last 20 commands entered during the current
CLI session.
Sets the speed of the Ethernet link to 10 Mbps.
Sets the speed of the Ethernet link to 100 Mbps.
Sets the speed of the Ethernet link to auto-negotiate.
Stores the current configuration in permanent memory.
log (config-diagnostics-log) level commands
Restores the factory default maximum Log file size.
Restores the default log output, which is disable.
Exits to the next higher level.
Sets the maximum size in Kbytes for the Log file.
Enables log to filesystem.
Enables log to serial line.
Shows the current configuration.
Displays the last 20 commands entered during the current
CLI session.
Stores the current configuration in permanent memory.
modem (tunnel-modem:1) level commands
Sets the CONNECT string used in modem emulation.
<string> = connect string.
default incoming connection
Default disables incoming network connections.
Default uses text type responses.
display remote ip disable
The incoming RING has nothing following it.
The incoming RING is followed by the IP address of the
caller.
Does not echo modem commands.
Does not echo the +++ characters when entering modem
command mode.
Echoes the +++ characters when entering modem com-
mand mode.
error unknown commands disable
Returns OK on unknown AT commands.
error unknown commands enable
Returns an error upon unknown AT commands.
Returns to the tunnel level.
incoming connection automatic
Automatically answer incoming network connections.
incoming connection disabled
Disable incoming network connections.
incoming connection manual
Wait for an ATA command before answering an incoming
network connection.
Removes optional CONNECT string information for mo-
dem emulation.
Asserts tunnel modem status with current configured val-
ues.
Uses numeric type responses.
XPort® Pro Lx6 Embedded Device Server Command Reference 80
