P/N: 4809654
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29JUL05 v2.0 05MusGT(4809654v2.0)
1-3
Fig. 1-j
Fig. 1-i
8mm HEADED SCREWS
1. PREPARATION/REMOVAL, cont’d
3. Locate and remove the remaining 10mm
headed bolts retaining the intake manifold
to the cylinder heads. There are five on
each side.
4. Remove the manifold and set aside so it
can be reinstalled after modifications to the
coolant crossover tube are made.
*** NOTE ***
Modification to the crossover tube will be com-
pleted in a later step.
O. Using a 1/2" ratchet, release the tension from
the accessory drive belt and remove it from the
car. This drive belt will be replaced with a
longer one later in the installation.
P. Locate and remove the stud that secures the
alternator in place as well as the stud-bolts
located to the right of the alternator. (See Fig.
1-j.)
Fig. 1-j
STUD BOLT
MODIFY STUD
REMOVE 13mm
HEADED BOLT
REMOVE
STUD BOLT
Q. There is a small tab that secures the wiring har-
ness in place on the valve cover that will need
to be removed to gain clearance for the super-
charger belt. This tab is best removed with a
small air saw but a grinder will work. After
removal, smooth the area to prevent damage to
the belt. (See Figs. 1-k, 1-l.)
*** NOTE ***
Do not allow material to enter the open cylinder
head runners.
Fig. 1-k
REMOVE TAB
