P/N: 4809654
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29JUL05 v2.0 05MusGT(4809654v2.0)
8-5
8B. CHARGE AIR COOLER INSTALLA-
TION, cont’d (H.O. KITS ONLY)
Fig. 8B-e | Driver’s side
Fig. 8B-g | Passenger’s side
Fig. 8B-f
Fig. 8B-h
5. Install the provided 3" x 3" sleeve and #48 hose
clamps onto the open end of tube “B”.
6. Using a 5/16-18 tap, tap the lower hole on the
driver’s and passenger’s side core support.
Locate the tube support brackets, 5/16-18 x
1/2" screws and washers. Loosely attach the
tube support brackets to the core support. (See
Fig. 8B-e, 8B-g.)
7. Install tube “C” between the 90° rubber elbow
and the 3" x 3" sleeve previously installed on
tube “B”. Attach tube “C” to its support bracket
using the #44 hose clamp. Tighten the clamp
and bracket. Secure all hose connections to this
point using the #48 hose clamps provided
adjusting for best fit and clearance.
8. Install the short end of tube “D” into the open
end of the passenger’s side 90° rubber elbow
previously install. (See Fig. 8B-f.)
9. Attach a 3" x 3" sleeve and #48 hose clamps to
the open end of tube “D”.
10. Install the short end of tube “E” into the sleeve
attached to tube “D”. Secure the tube support
bracket using the previously installed #48 hose
clamp. (See Fig. 8B-g.)
*** NOTE ***
For better fit, the transmission cooler lines (if
equipped) will need to be pushed upward slightly
so that tube “E” will fit between them and the A/C
compressor. (See Fig. 8B-g.)
11. Attach the cast discharge duct to the throttle
body using the supplied 4.5" sleeve and #72
hose clamps.
12. Using the remaining 3" x 3" bump sleeve and
#48 hose clamps, connect the long end of tube
“E” to the cast discharge tube. (See Fig. 8B-h.)
13. Secure all hose connections at this time, adjust-
ing for best fit and clearance.
TUBE “C”
UPPER
HOLE
LOWER HOLE TAPPED
WITH BRACKET INSTALLED
TUBE “D”
TUBE “E”
DISCHARGE DUCT
TUBE
SUPPORT
BRACKET
SHORT END
OF TUBE “E”
