P/N: 4809654
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29JUL05 v2.0 05MusGT(4809654v2.0)
7-3
Fig. 7-f
Fig. 7-h
Fig. 7-g
*** NOTE ***
If installing a standard output kit (non-cooled),
the 3/8" x 3.75" bolt and idlers w/spacers will be
installed in the upper hole location. H.O. kits
install in the lower hole. (See Fig. 7-c.)
K. Tighten all mounting plate hardware, making
sure the drive belt is properly routed and no
wiring or hoses are between the mounting sur-
faces. (See Fig. 7-g.)
SUPERCHARGER HARDWARE
.097"
SPACER
1.776"
SPACER
IDLER PILOT
SPACER
I. Locate the 8mm x 150mm bolt and washer.
Loosely install the bolt through the mounting
plate and remaining 2.712" long spacer into the
engine cover using Fig. 7-a for location refer-
ence.
J. Locate the supplied idler, 1.776" idler spacer,
idler pilot spacer, 3/8-16 x 3.75" long bolt and
washer. Install the bolt/washer through the
mounting plate, 1.776" spacer, supplied idler,
idler pilot spacer and into the triangle-shaped
bracket. Use Figs. 7-f to 7-h for assistance.
M. Attach the supplied length of 1/2" oil drain line
hose to the 1/2" barbed fitting on the super-
charger. Secure with the #8 hose clamp provid-
ed.
N. Install the supplied 1/8"NPT x -4 straight fitting
from assembly 4FU130-026 to the oil feed fit-
ting on the supercharger.
*** NOTE ***
Use only clean engine oil on the pipe threads.
Teflon tape or pipe sealant is not recommended
as if might loosen and cause blockage of the
small oil feed orifice resulting in possible super-
charger failure.
O. Attach the supercharger assembly to the mount-
ing plate using the previously installed hard-
ware. A 9/16" ratcheting end wrench will great-
ly aid this step.
P. Secure the oil drain hose to the prevously
installed brass fitting in the oil pan, making
sure to route in a smooth downward manner
away from moving or hot objects.
*** NOTE ***
Any dips, “uphill” sections, kinks or restrictions
may cause drainage problems and possible
supercharger failure.
Q. Attach the -4 oil feed hose to the straight -4 fit-
ting previously installed in the supercharger.
Secure away from moving of hot objects.
R. Using a 1/2" ratchet, rotate the factory spring
tensioner clockwise and install the accessory
drive belt. Refer to Fig. 7-e for proper belt rout-
ing.
L. Install the five 3/8-16 x 1.0" bolts and washers
through the back side of the mounting plate.
(See Fig. 7-g.)
7. SUPERCHARGER MOUNTING PLATE
INSTALLATION, cont’d
