P/N: 4809654
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29JUL05 v2.0 05MusGT(4809654v2.0)
5-2
Fig. 5-e
Fig. 5-f
G. Locate the supplied 1-1/4" expansion plug
(7P125-002.)
H. Coat the expansion plug with sealant. Using a
tube or socket that matches the recessed diame-
ter of the plug, install the plug flush with the
machined surface sealing the outlet of the
cross-over tube. (See Figs. 5-e, 5-f.)
I. Locate the supplied coolant relocation fitting,
sealing nut and O-ring washer. (See Fig. 5-g.)
J. Install the fitting in the location of the factory
coolant bleed plug. (See Fig. 5-h.) Screw the
jam nut all the way onto the fitting. Tighten the
fitting in the position shown. (See Fig. 5-h.)
Secure with the jam nut.
*** NOTE ***
It is recommended that sealant be used to seal
the thread of the fitting.
K. Reinstall the factory O-ring gaskets to the
crossover tube.
L. Set the coolant crossover tube back in its origi-
nal location.
M. Reinstall the two 10mm headed bolts through
the cross-over tube into the cylinder heads.
Temporarily install two intake manifold retain-
ing bolts through the cross-over tube into the
cylinder heads, where the manifold will be
secured. Leave these loose as they are there
only as a pilot for the cross-over tube.
Fig. 5-h
Fig. 5-g
FACTORY COOLANT
BLEED LOCATION
REMOVE:
NOT REUSED
RETAIN 90°
FITTING
5. COOLANT TUBE RELOCATION
