P/N: 4809654
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29JUL05 v2.0 05MusGT(4809654v2.0)
8-6
8C. CHARGE AIR COOLER INSTALLA-
TION, cont’d (H.O. KITS ONLY)
C.
COMPRESSOR BYPASS VALVE ASSEMBLY
INSTALLATION
1. Bypass valve #1:
a. Cut a piece of the provided 1" heater
hose approximately 3" long and
secure it to the by-pass valve inlet
(opposite the vacuum port) using the
#16 hose clamps provided.
b. Locate the 1" molded rubber 90°
elbow and cut approximately 6" from
the long end and 1" from the short
end. Attach the long end to the by-
pass valve discharge and secure using
the #16 hose clamps provided. (See
Fig. 8C-a, 8C-d.)
c. Attach the open end of the 3" long
hose to the by-pass port on tube “A”
and secure using a #16 hose clamp.
The open end of the 90° hose will be
connected to the inlet duct in a later
step. See Fig. 8C-d.)
Fig. 8C-a
(TRIM TO APPROX. 5.75")
APPROX. 4")
