P/N: 4809654
©2005 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
29JUL05 v2.0 05MusGT(4809654v2.0)
1-4
Fig. 1-m
1. PREPARATION/REMOVAL, cont’d
MODIFIED
STUD BOLT
Fig. 1-l
TAB REMOVED
R. Using a 15mm socket or wrench, remove the
nut that secures the capacitor resistor and
coolant hose support bracket to the stud bolt.
Using an 18mm socket or wrench, remove the
stud bolt. As seen in Fig. 1-j, the upper bolt is
removed from the timing chain cover. This bolt
will have to be modified by cutting off the
threaded end where the resistor attaches.
Modify and reinstall the bolt. (See Fig. 1-m.)
S. Disconnect the plug to the cam position sensor.
Remove the wiring harness from the retaining
clips that hold it to the valve cover. Move the
harness out of the way. This harness will have
to be relocated to gain clearance for the super-
charger.
