A SERVICE OF

logo

Publication 20D-UM002C-EN-P - November 2003
6-2 Communicating with Devices on an EtherNet/IP Link
Step 1: Configure the hardware
Before you can connect the DriveLogix system to the Ethernet network, you
must configure the 1788-ENBT communication daughtercard and make sure
it’s properly installed in the DriveLogix controller. Refer to Access Procedures
on page C-1 to understand how to gain access to the NetLinx daughtercard
slot on the DriveLogix controller.
You’ll need to configure the communication daughtercard slot number to 1 in
the RSLogix 5000 programming software. The DriveLogix controller uses slot
0.
For more information about configuring a 1788-ENBT communication
daughtercard, see:
For this card: See this document:
1788-ENBT 1788-IN054
!
EtherNet/IP