Publication 20D-UM002C-EN-P - November 2003
3
DH-485 configuration 10-9
DriveLogix controller and remote devices
over EtherNet/IP
6-23
DriveLogix Controller and Remote I/O on
ControlNet
7-22
DriveLogix Controller to DriveLogix
Controller on ControlNet
7-24
DriveLogix Controller to Other Devices on
ControlNet
7-28
DriveLogix controller to other devices
over EtherNet/IP
6-29
monitoring I/O module 4-18
monitoring rack-optimized connection
4-19
using a 1788-CN2DN linking device 8-11
F
fault bit 4-17
G
getting started
adding a local analog module
1-12
adding a local output module 1-10
changing module properties 1-14
changing project properties 1-5
configuringthe host PowerFlex 700S 1-6,
3-4
creating a project 1-4
creating tags 1-16
documenting I/O with alias tags 1-17
downloading a project 1-20
entering logic 1-18
overview 1-1
steps 1-3
viewing controller memory usage 1-22
viewing I/O tags 1-15
viewing scan time 1-21
H
hardware
ControlNet
7-2
DeviceNet 8-2
DH-485 10-1
EtherNet/IP 6-2
serial 9-2
Third-Party Link 11-2
host PowerFlex 700S
configuring
1-6, 3-4
placing 3-4
I
I/O configuration
FLEX I/O adapter
6-9–??
local ENBT module 6-8–??
I/O module
alias
4-16
communication format 4-8
configuring local 4-6
connection 2-12
DIN rail 4-5
electronic keying 4-7
example logic for monitoring a
rack-optmized connection
4-19
example logic for monitoring the module
4-18
fault bits 4-17
local overview 4-1
monitoring 4-16
inhibit operation
Drive Connection
3-13
I/O module 4-10
installing
communication card (ControlNet)
7-2
communication card (DeviceNet) 8-2
communication card (EtherNet/IP) 6-2
communication card (Third Party Link)
11-2
cover C-4
cover (high power drives) C-6
K
keying
drive
3-5
keying, electronic 4-7
3-5
L
local I/O
configuring
4-6
DIN rail 4-5
overview 4-1
logic
entering
1-18
Logix environment 2-1
low battery B-2
M
mapping address 6-18, 7-15
master/slave communication 9-10
memory
