Filter
Top Products
23
Adjustments (Continued)
Refer to Figure 5-2 and 5-3 and adjust belt tension as follows:
1. Remove and retain center plate/front cover and four screws.
2. Loosen, but do not remove, M10 lock nut with a 17 mm open end wrench.
3. Reset the tension on the drive belts as needed. Adjust the M8 tension screws in (clockwise) to increase
tension or out (counterclockwise) to decrease tension. Tighten lock nut to secure tension setting.
4. Replace center plate/front cover and secure with original screws.
Figure 5-2 – Box Drive Belt Tension Adjustment, Lower Belts (Infeed End)
• To reduce the risk associated with mechanical and electrical hazards:
− Turn electrical supply off and disconnect before performing any adjustments, maintenance or servicing the
machine or taping heads
WARNING