Filter
Top Products
26
Special Set-Up Procedure (Continued)
TAPING HEAD REMOVAL
4. Raise upper assembly to provide working room around lower taping head and remove tape from taping
head.
5. Lift the lower taping head, shown in Figure 6-3 and 6-1C, straight up to remove it from the case sealer bed.
6. Replace taping heads reverse of disassembly.
1. Remove tape from upper taping head and raise upper assembly to a convenient working height.
2. Pivot up the clamp that secures the upper taping head as shown in Figure 6-1B.
3. Hold upper taping head applying and buffing arms from under upper assembly, slide head forward and down
to remove. See Figure 6-2.
• To reduce the risk associated with sharp blade hazards:
− Keep hands and fingers away from tape cutoff blades under orange blade guards. The blades are extremely
sharp
WARNING
• To reduce the risk associated with muscle strain:
− Use proper body mechanics when removing or installing taping heads that are moderately heavy or may be
considered awkward to lift
CAUTION
• To reduce the risk associated with mechanical and electrical hazards:
− Turn electrical supply off and disconnect before performing any adjustments, maintenance or servicing the
machine or taping heads
WARNING
Figure 6-2 – Remove Upper Taping Head Figure 6-3 – Remove Lower Taping Head