Filter
Top Products
46
Maintenance
After each dive rinse the Cobalt and quick disconnect with fresh water. Be sure to rinse the underside recess where
the USB pins and water contacts are located. It may be rinsed or soaked with or without the quick disconnect installed.
The high pressure sensor is a ceramic material and is not affected by water. Replace the rubber cap on the high
pressure fitting when not in use to keep out dirt or contaminants. Store in a clean dry place out of direct sunlight. The
high pressure hose and quick disconnect assembly should be serviced every 2 years or 300 dives by an authorized
Atomic Aquatics Dealer or by the factory.
To avoid depleting the battery, do not store the Cobalt with the charging adapter plugged into the unit. Remove the
charger from the Cobalt when fully charged. Avoid placing the Cobalt near strong magnetic fields such as speakers or
large motors, as these could disturb the compass calibration.
Downloading the logbook
The Cobalt will store approximately 600 dives in the onboard logbook at the default sample rate of 30 seconds.
Downloading the Cobalt 2's dive log data to a personal computer is supported by a number of dive log applications for
Windows, Mac OS, and Linux. Check the Atomic Aquatics Website www.atomicaquatics.com for current information
regarding availability of download software.
Software upgrades
From time to time new software versions will be available for the Cobalt. It is always recommended that you use the
latest software version. The software version is listed in the Settings Menu/System Information screen. Check the
Atomic Aquatics Website www.atomicaquatics.com for available downloads and the most current information regarding
the how to obtain these updates.