Filter
Top Products
1101 and 1102 Secure Device Servers
724-746-5500 | blackbox.com
80
Serial and network connected UPSes must first be connected to, and configured to communicate with the console server:
For serial UPSes attach the UPS to the selected serial port on the console server. From the Serial and Network: Serial Port menu, configure the
Common Settings of that port with the RS-232 properties, etc. required by the UPS (refer to Chapter 5.1.1—Common Settings). Then select UPS
as the Device Type.
For each network connected UPS, go to the Serial & Network: Network Hosts menu and configure the UPS as a connected Host by specifying it
as Device Type: UPS and clicking Apply.
No such configuration is required for USB connected UPS hardware.
Figure 8-7. UPS connections.
Select the Serial & Network: UPS Connections menu. The Managed UPSes section will display all the UPS connections that have already been
configured.
Click Add Managed UPS.