Filter
Top Products
2
Installing, Upgrading, and Running DSET
Application On Windows Operating
System
This chapter provides information to install DSET application on Windows operating system. You can
install and run the application using the GUI or the Command Line Interface (CLI).
If you install or upgrade the DSET application on a system having OpenManage Server Administrator
version lower than 5.5 or an incompatible application, then an error message is displayed and the
installation is not completed. Install a compatible version of the Server Administrator or remove the
incompatible application and then install or upgrade DSET application.
If DSET application version 3.7.0 is already installed in the system and you try to install version earlier than
3.6.0 or greater than or equal to DSET 3.3, then an error message is displayed. Uninstall version 3.7.0 and
then run the setup program.
Installation Prerequisite For Windows Operating System
Before installing DSET application, make sure that:
• WMI service is installed and running.
– If WMI service is stopped, the application starts the service automatically and continues with
installation.
– If WMI service is disabled, installation of application terminates with an error message.
For installing Remote Provider, in addition to WMI, also make sure that:
• Operating system is Windows 2003 or later.
• OpenManage Server Administrator (if installed) version is 6.3 or later.
To enable the successful functioning of remote report collection from OpenManage Server Administrator
ensure the following:
• The managed system and the management station are on the same domain or there is a trust
relationship between the two domains.
• If you have a Windows Firewall configured on the management station or the managed system, make
the following configuration changes to enable remote Server Administrator CLI and software updates
to work successfully.
– Management Station:
1. Open TCP port 135.
8