Filter
Top Products
1-3
2. Insert the electronic chart card which contains a chart of your sea
area into the lower card drive.
Figure 1-3 Inserting chart card
Note: Always close the card drive cover to keep humidity and water
out of the drive.
1.3 Turning the Power On/Off
Turning the power on
Press the [POWER] switch at bottom left-hand side of the unit. You
will hear a “peep” when turning on the power. To turn off the power
press the switch again.
After turning on the power the display changes in the sequence illus-
trated in Figure 1-4. About 20 seconds later accurate own ship’s posi-
tion is displayed in case of the GP-3300.
GPS PLOTTER
ON
POWER
OFF
9
6
32
5
87
4
1
0
BRILL
ECONO
E
N
T
CEN
TER
SELECT
MARK
COLOR
FR/TO WPT
ROUTE ALARM
TRACK
COLOR
PLOT
INTVL
CHART
C
L
R
EVENT
PLOT
MODE
VIDEO
PILOT
NAV
DATA
MANU
Power switch
ZOOM
IN
ZOOM
OUT
CURSOR
ON/OFF
Figure 1-4 GD-3300/GP-3300
For the GP-3300, at the first power application after installation, it
takes about two minutes to acquire GPS satellite data, called the al-
manac. While the unit is acquiring the almanac, the indication “CST”
appears at the top of the display. “CST” is replaced by “2D” or “ACQ”
after the almanac is acquired. If the vessel has moved more than 600
miles with the system turned off, reenter estimated position on the
GPS INITIAL SETTINGS menu (key sequence: [MENU], [8], [
]).
If asterisks appear instead of ship’s position data, this means there is
no navigation input. Check to make sure proper navigation aid is
selected on the INITIAL SETTINGS menu (keying sequence:
[MENU], [8]).