Filter
Top Products
CHAPTER 11: PROGRAMMING GROUP 2 - METER CALIBRATION GROUP 2, FUNCTIONS 0–2
EPM 5300 SERIES ADVANCED POWER METERS – INSTRUCTION MANUAL 11–85
11.2 Group 2, Functions 0–2
- HIGH END CALIBRATION OF VOLTAGE CHANNELS, HIGH AND LOW END
CALIBRATION OF AMPERAGE CHANNELS -
To change the calibration (high end—Functions 0 and 1):
Note
Press MAX/MIN/LIMITS at any time to cancel before storing the last digit or switch.
Step 1:
a. Enter Group Level of Programming Mode
(see Chp. 8).
b. Press MAX/MIN/LIMITS until 2. appears in
upper display.
c. Press AMPS to activate the Group.
A one-digit password is required to continue.
d. Press VOLTS until 5 appears.
e. Press AMPS to select.
Step 2:
Refer to Table 11-1 for Function Number that
corresponds to the area requiring calibration. Calibration
for each area begins with A and then moves to B and C.
a. Press MAX/MIN/LIMITS to change Function number.
MAX/MIN
LIMITS
KVAR
PF
KW
KVA
FREQ
KWHKVAH
AC VOLTS
AC AMPS
POWER
NC
B
A
MAX
MIN
A
N
B
N
C
N
A
B
B
C
C
A
LM2
LM1
NEXT
PHASE
VOLTS
AMPS
POWER
MAX/MIN
LIMITS
KVAR
PF
KW
KVA
FREQ
KWHKVAH
AC VOLTS
AC AMPS
POWER
NC
B
A
MAX
MIN
A
N
B
N
C
N
A
B
B
C
C
A
LM2
LM1
NEXT
PHASE
VOLTS
AMPS
POWER