Filter
Top Products
CHAPTER 11: PROGRAMMING GROUP 2 - METER CALIBRATION GROUP 2, FUNCTIONS 0–2
EPM 5300 SERIES ADVANCED POWER METERS – INSTRUCTION MANUAL 11–87
Step 1:
a. Enter Group Level of Programming Mode
(see Chp. 8).
b. Press MAX/MIN/LIMITS until 2. appears in upper
display.
c. Press AMPS to activate the Group.
A one digit password is required to continue.
d. Press VOLTS until 5 appears.
e. Press AMPS to select.
Step 2:
a. Press MAX/MIN/LIMITS until 22. appears in upper
display.
b. Press AMPS to activate. (Calibration begins with Amps
A, then moves to B and C).
Middle and lower displays blank.
Step 3:
New value moves to middle display.
Lower display indicates the calibrated reading after
10-15 seconds.
To enter the half scale value in lower display,
a. Press VOLTS to select digits.
b. Press AMPS to store and proceed to B or C within the
group.
c. Press MAX/MIN/LIMITS to end calibration procedure.
See Chapter 14 to Exit.
MAX/MIN
LIMITS
KVAR
PF
KW
KVA
FREQ
KWH
KVAH
AC VOLTS
AC AMPS
POWER
NC
B
A
MAX
MIN
A
N
B
N
C
N
A
B
B
C
C
A
LM2
LM1
NEXT
PHASE
VOLTS
A
MPS
POWER