Filter
Top Products
Repair
311594Z 19
Slider Cylinder Collector Kit 247341
NOTE: Slider Cylinder Collector Kit 247341 includes
parts to install two slider cylinder collectors. Use all the
new parts in the kit. The kit includes manual 311607.
1. Perform the Disassembly procedure on page 15.
2. Jog motor to move slider piston (9) up, giving ade-
quate clearance to fit collector (67) between slider
cylinder and piston rod.
3. See F
IG
. 7. Position the collector (67) over the cou-
pling nut (14) and drop it down onto the pump piston
rod.
4. Jog motor to move slider piston (9) to bottom of
stroke, allowing reconnection of coupling nut (14).
5. Ensure that the collars (13) are in place in the cou-
pling nut (14).
6. Place a 3/4 in. wrench on the flats of the slider pis-
ton (9), to keep it from turning when you are tighten-
ing the coupling nut (14). Orient the wrench so it is
braced against one of the tie rods (3) or the stand.
Tighten the coupling nut (14) onto the slider piston
(9) and torque to 75-80 ft-lb (102-108 N•m).
7. See F
IG
. 8. Push the collector (67) up onto the bot-
tom of the slider cylinder (2) so it seats securely.
Install the three setscrews (68) finger-tight.
8. Install the shields (72) by engaging the bottom lips
with the groove in the wet-cup cap. Snap the two
shields together.
9. Repeat for the other side.
F
IG
. 7. Position Collector
ti9538b
14
67
9
F
IG
. 8. Install Collector
ti9539a
2
67
68