Filter
Top Products
1 - 2
Connecting the Development Engine to the PC
The development OEM engine can connect to a PC for evaluation.
Connecting with USB
Note: If using the N56XXX-XXX-XX5 engine with USB Micro-B, do not supply power through the flex connector. Doing so
may damage the host or engine. The N56XXX-XXX-XX5 engine will only communicate USB through the Micro-B
connector. The N56XXX-XXX-XX3 engine will only communicate USB through the 10 pin modular connector.
1. Turn off power to the terminal/computer.
2. If using full-speed USB, connect the USB interface cable to the interface board and to the matching USB port on the
computer.
If using high-speed USB, connect the USB interface cable to side of the engine and to the USB port on the computer.
Note: For additional USB programming and technical information, refer to Honeywell’s “USB Application Note,” available at
www.honeywellaidc.com.