Honeywell 5610/5613 Marine Radio User Manual


 
2 - 20
RS232 Stop Mode
Scan the following bar code to force the engine into a stop mode. Restart the engine by using a trigger pull, nWake, or RxD
toggle.
Scanner to Bioptic Communication
The following settings are used to set up communication between Honeywell scanners and bioptic scanners.
Note: The scan engine’s baud rate must be set to 38400 and the RS232 timeout must be set to 3000 in order to communicate
with a bioptic scanner. See "RS232 Modifiers" on page 2-16, and RS232 Timeout on page 2-19 for further information.
Scanner-Bioptic Packet Mode
Packet Mode On must be scanned to set the scan engine’s format so it is compatible with a bioptic scanner. Default =
Packet Mode Off.
Scanner-Bioptic ACK/NAK Mode
Bioptic ACK/Nak On must be scanned so the scan engine will wait for an ACK or NAK from a bioptic scanner after each
packet is sent. The Scanner-Bioptic ACK/NAK Timeout (below) controls how long the scan engine will wait for a response.
Default = Bioptic ACK/NAK Off.
RS232 Stop Mode On
* Packet Mode Off
Packet Mode On
* Bioptic ACK/NAK Off
Bioptic ACK/NAK On