Filter
Top Products
3 - 10
Aimer Delay
The aimer delay allows a delay time for the operator to aim the scan engine before the picture is taken. Use these codes to set
the time between when the trigger is pulled and when the picture is taken. During the delay time, the aiming light will appear,
but the LEDs won’t turn on until the delay time is over. Default = Off.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the bar code below, then set the time-out by scanning
digits (0 - 4,000 ms) from the Programming Chart inside the back cover of this manual, then scan Save.
Aimer Mode
This feature allows you to turn the aimer on and off. When the Interlaced bar code is scanned, the aimer is interlaced with the
illumination LEDs. Default = Interlaced.
Centering
Use Centering to narrow the scan engine’s field of view to make sure that when the scanner is hand-held, it reads only those bar
codes intended by the user. For instance, if multiple codes are placed closely together, centering will insure that only the
desired codes are read. (Centering can be used in conjunction with Aimer Delay, page 3-10, for the most error-free operation
in applications where multiple codes are spaced closely together. Using the Aimer Delay and Centering features, the scanner
can emulate the operation of older systems, such as linear laser bar code scanners.).
If a bar code is not touched by a predefined window, it will not be decoded or output by the scan engine. If centering is turned
on by scanning Centering On, the scan engine only reads codes that pass through the centering window you specify using the
Top of Centering Window, Bottom of Centering Window, Left, and Right of Centering Window bar codes.
200 milliseconds
400 milliseconds
* Off (no delay)
Delay Duration
Off
* Interlaced