Honeywell 5610/5613 Marine Radio User Manual


 
2 - 19
RS232 Timeout
When using Flow Control with Timeout, you must program the length of the delay you want to wait for CTS from the host.
Set the length (in milliseconds) for a timeout by scanning the bar code below, then setting the timeout (from 1-5100 millisec-
onds) by scanning digits from the inside back cover, then scanning Save.
XON/XOFF
Standard ASCII control characters can be used to tell the scan engine to start sending data (XON/XOFF On) or to stop
sending data (XON/XOFF Off). When the host sends the XOFF character (DC3, hex 13) to the scan engine, data transmis-
sion stops. To resume transmission, the host sends the XON character (DC1, hex 11). Data transmission continues where
it left off when XOFF was sent. Default = XON/XOFF Off.
ACK/NAK
After transmitting data, the scan engine waits for an ACK character (hex 06) or a NAK character (hex 15) response from the
host. If ACK is received, the communications cycle is completed and the scan engine looks for more bar codes. If NAK is
received, the last set of bar code data is retransmitted and the scan engine waits for ACK/NAK again. Turn on the ACK/
NAK protocol by scanning the ACK/NAK On bar code below. To turn off the protocol, scan ACK/NAK Off. Default = ACK/
NAK Off.
Flow Control with Timeout
* RTS/CTS Off
RS232 Timeout
XON/XOFF On
* XON/XOFF Off
ACK/NAK On
* ACK/NAK Off