Chart Select
Chart Select allows you to choose what chart to use if you have built-
in charts or a map card. If you select Auto, your unit will select a chart automatically.
T
o activate or de-activate Chart Select:
1. Highlight Chart Select on the Navigation main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to select which chart to use. (Default = Auto)
NVB Chart Preference
NVB Chart Preference allows you to choose what built-in chart to use
if you have an NVB unit. If you select Auto, your NVB unit will select a chart automatically.
To activate or de-activate NVB Chart Pr
eference:
1. Highlight NVB Chart Preference on the Navigation main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to select which chart to use. (Default = Auto)
Set Simulation Position
(Advanced)
Set Simulation Position allows you to set the position of the boat used in the Simulator.
T
o set the Simulation Position:
1. Activate the cursor and move it to the coordinates from where you want simulation to start.
NOTE: The cursor must be active in order for this procedure to work.
2. Make sure you are in Advanced User Mode, then highlight Set Simulation Position on the Chart
main menu.
3. Use the RIGHT 4-WAY Cursor Control key to change the Simulation Position setting. A
confirmation dialog box will appear to allow you to change your mind, or to confirm your choice.
If the cursor was not active before you began this procedure, you will see an error message. Exit
the menu, set the cursor, then try again.
Set Map Offset
(Advanced)
Set Map Offset allows you to change the map offset used by the 1100 Series™.
NOTE: The Map Offset will be applied to all maps and not just the map that requires the correction. The Map
Offset should be cleared if a different map is to be used.
To change the Map Offset setting:
1. Activate the cursor and move it location where the Map Offset will be applied.
NOTE: The cursor must be active in order for this procedure to work.
147
531617-1_A - 1197c_ManE.qxp 11/6/2007 4:39 AM Page 147