Filter
Top Products
190
Frequency setting by analog input (terminal 1, 2, 4)
The motor will not rotate ... Why?
Check that [EXT] is lit.
[EXT] is valid when Pr. 79 = "0" (initial value).
Use to lit [EXT].
Check that wiring is correct. Check once again.
Change the frequency (0Hz) of the minimum value of potentiometer (at 0V)
Adjust the frequency in calibration parameter C2 Terminal 2 frequency setting bias frequency. (Refer to page
193.)
When you want to compensate frequency setting, use terminal 1.
For details, refer to page 191.