Filter
Top Products
Basic Recording
✤ The Zero Memory function works in both Camera and Player
modes.
✤ You can mark a point on a tape that you want to return to following
playback.
1. Set the Power switch to CAMERA or PLAYER.
2. Set the Mode switch to TAPE.
3. Press the ZERO MEMORY button on the remote
control before the recording or during playback at
the point where you wish to return.
■ The time code is changed to a tape counter that
is set to Zero Memory with the 0:00:00
(Zero Memory indicator).
■ If you want to cancel the Zero Memory function,
press the ZERO MEMORY button again.
4. Finding the zero position.
■ When you have finished playback, fast forward
or rewind the tape in stop mode.
The tape stops automatically when it reaches
the zero position.
■ When you have finished recording, set the
Power switch to PLAYER and press the
(REW) button.
The tape stops automatically when it reaches the zero position.
5. The tape counter with the (Zero Memory indicator) disappears
from the display and the tape counter is changed to the time code.
[ Notes ]
■ In the following situations, Zero Memory mode may be canceled
automatically:
-
At the end of the section marked with the Zero Memory function.
- When the tape is ejected.
- When you remove the Battery pack or power supply.
■ The Zero Memory may not function correctly where there is a
break between recordings on the tape.
Setting the Zero Memory (VP-D453(i)/D454(i)/D455(i) only)
4242
ENGLISH
✤ CAMERA Player Zero
Memory
✤
1. CAMERA PLAYER
2. TAPE
3.
ZERO MEMORY
■
0:00:00
■ ZERO
MEMORY
4.
■
■
PLAYER REW
5.
■
-
-
-
■
\( VP-D453(i)/D454(i)/D455(i))
œ
1