Filter
Top Products
13
© 2011 Schneider Electric All Rights Reserved.
ZL0093-0A
11/2011
EM3555
Quick Setup Instructions
QUICK SETUP INSTRUCTIONS
These instructions assume the meter is set to factory defaults. If it has been
previously congured, all optional values should be checked.
1. Press the
+
or
–
button repeatedly until SETUP screen appears.
2. Press to the PASWD screen.
3. Press through the digits. Press
+
or
–
to select the password (the default
is 00000). Exit the screen to the right.
4. Press
+
or
–
to select the parameter to configure.
5. The first Setup screen is S COM (set RS-485 communications).
a. Press to the ADDR screen and through the address digits. Press
+
or
–
to select the Modbus address.
b. Press to the BAUD screen. Press
+
or
–
to select the baud rate.
c. Press to the PAR screen. Press
+
or
–
to select the parity.
d. Press back to the S COM screen.
6. Press
–
to the S CT (Set Current Transducer) screen.
a. Press to the CT V screen. Press
+
or
–
to select the voltage mode
Current Transducer output voltage (default is 0.33).
b. Press to the CT SZ screen and through the digits. Press
+
or
–
to
select the CT size in amps.
c. Press back to the S CT screen.
7. Press
–
to the S SYS (Set System) screen.
a. Press to the SYSTM screen. Press
+
or
–
to select the System Type
(see wiring diagrams).
b. Press back to the S SYS screen.
8. (Optional) Press
–
to the S PT (Set Potential Transformer) screen. If PTs
are not used, then skip this step.
a. to the RATIO screen and through the digits. Use the
+
or
–
buttons
to select the Potential Transformer step down ratio.
b. back to the S PT screen.
9.
–
to the S V (Set System Voltage) screen.
a. to the VLL (or VLN if system is 1L-1n) screen and through the digits.
Use the
+
or
–
buttons to select the Line to Line System Voltage.
b. back to the S V screen.
10. Use the to exit the setup screen and then SETUP.
11. Check that the wrench is not displayed on the LCD.
a. If the wrench is displayed, press
+
or
–
to nd the ALERT screen.
b. Press through the screens to see which alert is on.
For full setup instructions, see the conguration instructions on the following
pages.