Filter
Top Products
PowerLogic
TM
Series EM4000 930-134-01-A.00
Installation Guide 11/2013
6 ©2013 Schneider Electric All Rights Reserved
Installation
This section contains the following installation topics:
• “Pre-Installation” on page 6
• “Installation Procedures” on page 7
• “Connecting Pulse Inputs” on page 26
Pre-Installation
The pre-installation checklist and site planning must be performed before installing
the equipment at the site.
Receiving
The equipment required for each PowerLogic EM4000 meter installation includes:
• high-density meter (PowerLogic EM4033 or PowerLogic EM4080)
• For the PowerLogic EM4033 and PowerLogic EM4080, one 12-ft (4-m) AMP
cable with one 50-pin connector supplied with each unit
• CD and meter configuration software, this installation manual and an installation
record form
When you receive your order, verify that the items listed above are included with
the shipment, and visually inspect them for damage. If any parts are missing or
damaged, contact your Schneider Electric representative.
Pre-Installation Checklist
The installer must provide the following information, tools, and equipment before
proceeding with the installation:
• certified current transformers for metering (not supplied)
• an appropriate 15-Amp maximum circuit breaker or a fused disconnect switch
for the type of panel
• current/voltage meter to test the phasing of panels
• RJ45 Ethernet patch cable
• 4-wire 14 AWG (1.63 mm
2
) cable for three-phase wye connected circuits, or 3-wire 14
AWG (1.63 mm
2
) cable for a single-phase wye connected circuits
• small flat-head screwdriver
• #2 Phillips screwdriver
• crimping tool
• 18 AWG butt splice connector
• wire strippers
• four 1-inch (25 mm) #8 mounting screws suitable for selected mounting surface
Site Planning
1. Determine the number of PowerLogic EM4000 series meters to be installed and
ensure adequate space. For clearances, see Figure 3 on page 8.
2. Determine the number of Ethernet drops required, and ensure they are installed
before installing the PowerLogic EM4033 and EM4080 meters.