Filter
Top Products
6-4
www.topconpa.com
Weather Station Operation/Installation Manual
Ensure that the Pole Mount is 11. orientated with the direction
arrow sticker (on top of the Weather Station) pointing in the
vehicle’s direction of travel
Screw the 12. Back Nut (Figure 5-3 on page 5-3) up tight to lock in
the position of the Weather Station sensor
Route the 13. A3372 harness (Figure 5-2 on page 5-2), along the
roof of the cabin and enter the inside of the cabin through
vehicle approved Gromets
Fix the harness to the roof using the 5 14. self adhesive back clips
(Y957) provided
Route the harness inside the cabin to where the X20 console is 15.
installed
Connect the 16. 9 pin connector of the A3372 harness to the CAN
Bus Port (Figure 2-4 on page 2-9 of the X20 console manual) at
the back of the X20 console
Connect the 17. 2 Pin Weatherpack connector on the A3372
harness to the X20 console’s Switched Power connector on the
X20’s Power harness
Aligning the mounting screw (nearest humidity
sensor) is important, as it will ensure that the correct
wind direction is displayed on the X20 console.
The direction arrow sticker is an indication only.
NOTICE