Filter
Top Products
9-16 User’s Manual
Troubleshooting
Bios Beep Sounds
Memory expansion
Refer also to Chapter 8, Optional Devices, for information on installing
memory modules.
Sound system
Refer also to documentation for your audio devices.
Problem Procedure
Beep sounds Beep volume can be set to High/Medium/Low/Off
using the Bios Setup Program. The Default is
Medium.
The volume for the loud beep sound that occurs
when there is a memory error cannot be adjusted.
Problem Procedure
Beep sounds.
(Two beeps, a dash
and a dot, for a
defective memory
module in slot A.
Three beeps, a dash
and two dots for slot B.
When both beeps
sound, both memories
in slot A and B are
defective.)
Make sure the memory module installed in the
memory slot is compatible with the computer.
If an incompatible module has been installed,
follow the steps below.
1. Turn off the computer.
2. Disconnect the AC adaptor and all peripheral
devices.
3. Remove the battery pack.
4. Remove the memory module.
5. Install the battery and/or connect the AC
adaptor.
6. Turn on the power.
If problems persist, contact your dealer.
Error beep sounds
(Five beeps, a dash
and four dots).
The Intel
®
940GML model cannot boot if a
memory module of over 2GB is installed. Verify
that the installed memory does not exceed 2GB.
Problem Procedure
No sound is heard Adjust the volume control dial.
Check the software volume settings.
Make sure the headphone connection is secure.
If problems persist, contact your dealer.