Xantrex Technology TS400 Marine Battery User Manual


 
Installing the TS400
975-0055-01-01 219
Step 9: Hardwiring the AC Output
If you wish to permanently connect additional AC outlets, Xantrex
recommends hardwiring the AC output connections.
To hardwire the AC output connections:
1. Turn the On/Standby switch to Standby ( ).
2. Remove the knockout using a slot screwdriver as shown in
Figure 2-6. Do not leave the knockout inside the wiring box.
WARNING: Fire, shock, and energy hazards
Make sure wiring is disconnected from all electrical sources
before handling. All wiring must be done in accordance with
local and national electrical wiring codes. Do not connect the
output leads of the inverter to any incoming AC source.
Figure 2-6
Removing the Knockout