A SERVICE OF

logo

Open as PDF
next previous
Getting Started
ARM DUI 0224F Copyright © 2003-2007 ARM Limited. All rights reserved. 2-3
2.2 Setting the configuration switches
Configuration switches S1 and S6, shown in Figure 2-1, control how the PB926EJ-S
configures itself and the action to take after reset.
Figure 2-1 Location of S1-1 and S6-1
2.2.1 Boot memory configuration
The configuration switches S1-1 to S1-8 determine boot memory type, the FPGA
image, and the Logic Tile image, memory configuration, and FPGA options at power
on.
Use switch S1-1 and S1-2 to select the boot device as shown in Table 2-1 on page 2-4.
Note
If the switch lever is down, the switch is ON. The default is OFF, switch lever up.