A SERVICE OF

logo

SKU 94143 For technical questions, please call 1-800-444-3353 PAGE 11
To Attach An Bit:
Bit With Two Mounting Holes
Bit With One Mounting Hole
HYDRAULIC
MOTOR
(4)
AUGER
COUPLER
(59)
HITCH PIN
(57)
BIT WITH
TWO MOUNTING
HOLES
HITCH PIN
(57)
BIT WITH
ONE MOUNTING
HOLE
HYDRAULIC
MOTOR
(4)
AUGER
COUPLER
(59)
HITCH PIN
(57)
FIGURE F
1. Slide the Bit (65) onto the Auger Coupler (59) until the mounting hole in the Bit
aligns with the mounting hole in the Auger Coupler. Then lock the Bit in place,
using one Hitch Pin (57). (See Figure F.)
NOTE: 2. If an Bit (65) has two mounting holes, lock the Bit in place using two
Hitch Pins (57). Both Hitch Pins are required on Bits with two mounting holes.
(See Figure F.)
Check to make sure all Hitch Pins (57) used extend completely through the 3.
mounting holes and out the far side of the connection. (See Figure F.)