Central Hydraulics 94143 Manual

A SERVICE OF

next previous

SKU 94143 For technical questions, please call 1-800-444-3353 PAGE 8

ASSEMBLY INSTRUCTIONS

To Connect The Boom To The Frame Assembly:

BOOM (66)

HOSES & WIRES

HEX HEAD BOLTS (2)

NUTS (20)

FIGURE A

FRAME ASSY. (35)

1. Feed the Hoses and Wires extending from the bottom of the Boom (66) through

the opening at the rear of the Frame Assembly (35). (See Figure A.)

Use the 2. six Hex Head Bolts (2) and six Nuts (20) to secure the Boom (66) to the

Frame Assembly (35). (See Figure A.)

To Adjust The Handle Angle:

HEX HEAD BOLT (67)

HANDLE ASSEMBLY (69)

FIGURE B

1. The Handle Assembly (69) can be adjusted 16° to the left and 16° to the right.

This will allow you to operate the Auger on uneven surfaces. (See Figure B.)

Loosen the Hex Head Bolt (67) to rotate the Handle Assembly (69). Once the 2.

Handle Assembly angle has been adjusted, rmly retighten the Hex Head Bolt.

(See Figure B.)