SKU 94143 For technical questions, please call 1-800-444-3353 PAGE 19
To check and adjust the Linkage:5.
SCREWDRIVER
(NOT INCLUDED)
LOCKING NUT
TRIGGER
HANDLE
BALL COUPLER
LINKAGE
SPOOL AND CLEVIS
CONTROL VALVE
FIGURE L
a. Squeeze the right side of the Trigger (61). Check to see that the Spool in
the Control Valve is pushed in against its stop. If the Trigger hits against the
Handle before the Spool is pushed in against its stop, the Linkage needs to
be adjusted. (See Figure L.)
Squeeze the left side of the Trigger (61). Check to see that the Spool in the b.
Control Valve is pulled out against its stop. Once again, if the Trigger hits
against the Handle before the Spool is pulled out against its stop, the Linkage
needs to be adjusted.
(See Figure L.)
To adjust the Linkage, place a screwdriver into the Spool clevis to keep the c.
Linkage from turning. Loosen the Locking Nut from the Ball Coupler.
(See Figure L.)
If the right side of the Trigger (61) needs to be adjusted, turn the Linkage d.
counterclockwise (CCW). If the left side of the Trigger (61) needs to be ad-
justed, turn the Linkage clockwise (CW). (See Figure L.)
Check your progress periodically by squeezing the right side of the Trigger e.
(61). The Linkage has been properly adjusted when the Spool is pushed in
against its stop at the same time the Trigger hits the Handle. (See Figure L.)
NOTE: 6. Always dispose of old engine oil and old hydraulic oil in accordance with
local, state, and federal regulations.
CAUTION! All maintenance, service, or repairs not mentioned in this manual
must only be performed by a qualiî‚żed service technician.
