SKU 94143 For technical questions, please call 1-800-444-3353 PAGE 18
INSPECTION, MAINTENANCE, AND CLEANING
DANGER! Make sure the Engine Kill Switch (68) of the Auger is in its “OFF” position
and the Power Switch of the Engine is in its “OFF” position prior to performing
any inspection, maintenance, or cleaning of the machine.
Before each use,1. inspect the general condition of the Auger. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, dam-
aged electrical wiring, damaged hydraulic hoses, loose hydraulic hose ttings,
and any other condition that may affect the safe operation of the Auger. If abnor-
mal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
Before each use, 2. check the Engine oil level. If necessary, ll the crankcase of
the Engine with the proper amount and type of engine oil. Refer to the Engine
manufacturer’s manual for all inspection, maintenance, and cleaning in-
structions.
Before each use, 3. check the hydraulic oil level. If necessary, remove the Hydrau-
lic Oil Tank’s Oil Plug (36). Fill the Hydraulic Oil Tank (33) with 10 weight hy-
draulic oil to approximately one inch from the top of the Tank. (The total hydraulic
oil capacity is 4 gallons.) Then, replace the Oil Plug. (See Figure G, page 13.)
After every 50 hours of use, 4. drain the old hydraulic oil and rell the Hydraulic
Oil Tank (33) with 10 weight hydraulic oil.
