SKU 94143 For technical questions, please call 1-800-444-3353 PAGE 13
FILL WITH
10 WEIGHT
HYDRAULIC
OIL
HYDRAULIC OIL TANK (33)
FIGURE G
2. To do so, remove the Hydraulic Oil Tank’s Oil Plug (36). Fill the Oil Tank to ap-
proximately one inch from the top of the Tank. (The total hydraulic oil capacity is
4 gallons.) Then, replace the Oil Plug. (See Figure G, above.)
Make sure the Bit (65) is elevated from the ground surface.3.
Bit (65)
TRIGGER (61)
(RIGHT SIDE = CLOCKWISE / DIGGING ROTATION)
(LEFT SIDE = COUNTERCLOCKWISE / REVERSE ROTATION)
ENGINE KILL SWITCH (68)
FIGURE H
4. Turn the Auger’s Engine Kill Switch (68) to its “ON” position.
IMPORTANT: The Engine Kill Switch allows the operator to shut off the Engine
(15) while continuing to grip the Handle Assembly (69) with both hands. For
safety purposes, the operator must ALWAYS shut off the Engine by turning the
Engine Kill Switch to its “OFF” position while maintaining a rm grip on the
Handle Assembly. (See Figure H.)
Start the Engine (15) and run at slow idle.5.
(See Engine manufacturer’s manual for complete instructions.)
