SKU 94143 For technical questions, please call 1-800-444-3353 PAGE 14
Squeeze the right side of the Trigger (61) until the Bit (65) spins smoothly in a 6.
clockwise (digging) rotation. (See Figure H.)
Turn the Engine Kill Switch (68) to its 7. “OFF” position to shut off the Engine.
(See Figure H.)
Wait until the Bit (65) stops rotating. Then relieve the hydraulic system pressure 8.
by squeezing the right side of the Trigger (61) several times while the Engine (15)
is off. (See Figure H.)
Remove the Oil Plug (36) and check the hydraulic oil level in the Hydraulic Oil 9.
Tank (33). If necessary, ll the Oil Tank to one inch from the top of the Oil Tank.
Then, replace the Oil Plug. (See Figure G.)
Squeeze the left side of the Trigger (61) several times. Then, repeat Step #9.10.
OPERATING INSTRUCTIONS
Turn the Auger’s Engine Kill Switch (68) to its 1. “ON” position.
Start the Engine (15) and run at slow idle.2.
(See Engine manufacturer’s manual for complete instructions.)
3. Use the Handle Assembly (69) to position the Bit (65) bit to the center of the hole
to be dug. (See Figure I.)
